A milling vise is a versatile way to hold parts
securely. It is accurately made so it can be aligned to the mill table. It also
has a jaw that pulls down as well as in to keep parts from being pulled up by
the milling cutter.
When mounting the mill vise to the table, this
base will allow the vise to be rotated to any angle. The red anodized base is
laser engraved with angle measurements in 1° increments all the way around. A
witness mark is engraved on the side of the rotating collar that holds the vise.
The locking washers can be loosened, which allows the vise to slide forward and
back in the fixture for further adjustment. A locking ring underneath pulls the
collar down onto the base to lock it securely when the two hold-down screws are
tightened. The low profile tooling plate base only raises the height of the vise
1/2". Four T-nuts and hold-down bolts are included. The rotating vise base
eliminates clamping and unclamping the vise to produce angles. Once mounted
square to the table, the vise can be positioned using the laser engraved
protractor scale as a guide for setting the angle. Properly positioned, the
rotating base can even be used as a simple rotary table to drill or machine
small, radially symmetrically patterns.
If you do not already have a vise and are
considering purchasing both a vise and a rotating base, they can be purchased
together at a price that is less than the two purchased individually
Click
for details